Rod/Strut, stabiliser - A38-1187 ACKOJA

The stabilizer is needed to reduce the horizontal roll of the car body when cornering and various deviations in the horizontal plane. The stabilizer strut provides a movable connection between the elastic stabilizer and the hub or steering knuckle due to the existing hinges. Depending on the design of the suspension, the struts can also be different.

The ACKOJA brand Rod/Strut, stabiliser is one part of the chassis used to provide lateral stability to the vehicle body.

1. CUBE (Z12)
2. MICRA IV (K13_)
3. MARCH IV (K13_)
4. MARCH / MARCH ACTIVE IV (K13_)
5. MICRA IV (K13_, MK13K_)
6. NV200 / EVALIA Bus
7. EVALIA Bus
8. NV200 Bus
9. NV200 Van
10. CLIO III (BR0/1, CR0/1)
11. EURO CLIO III (BR0/1, CR0/1)
12. CLIO CAMPUS III (BR0/1, CR0/1)
13. LUTECIA III (BR0/1, CR0/1)
14. CLIO III Grandtour (KR0/1_)
15. CLIO III Sportour (KR0/1_)
16. NOTE (E11, NE11)
17. MICRA III (K12)
18. MARCH III (K12)
19. MODUS / GRAND MODUS (F/JP0_)
20. MICRA C+C III (K12)
21. See more in applications

The construction of the stabilizer strut

The stabilizer strut is small in length, usually from 5 to 25 cm, hinges or silent blocks are welded to it. It is attached to the main elements (stabilizer and steering knuckle) with a threaded connection. A boot protects the hinge, and grease is put inside. There are many rack options and this is dictated by various design requirements. Symmetrical (installed on either side, either end up), asymmetrical (right and left, hinges are attached at different angles). The rear struts, unlike the front ones, are not symmetrica